Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: NormB on October 01, 2018, 09:23:53 AM
-
Finally almost finished with configuration but something is strange not sure why. When I auto zero Z the DRO registers correctly 2" where I set it to be after zeroing but when I look at machine coordinates I see a crazy number like .485 I am not sure why it is not agreeing with my work coordinates. Any help is greatly appreciated.
-
i think you have to read a Little bit about machine coordinates and work coordinates.
machine coordinates will only be set to Zero by doing a reference with reference Switches.