Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fishmore on September 26, 2018, 09:07:18 AM
-
Hello all,
I just installed Geckodrive G540. Unfortunately the xml file crashes my computer so I am manually going through all the settings. I have almost everything all set however the MDI line isn't working correctly. If I type in G0X1.5 the table doesn't move to x=1.5 but it does move 1.5". In other words if the x is at 2.000" and I type G0X1.5 the table will move to x=3.5.
Can you please let me know which setting I should be looking for?
Thanks
-
Hi,
sounds like your in incremental mode.
Confirm that you are in absolute distance mode and IJ Incremental mode.
Next read up on G90 and G91 modes. MDI a G90 to be sure.
Craig
-
That was it,
Thanks Craig