Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Thinder on September 20, 2018, 08:57:57 PM
-
Hi im super new to all of this but, ive got a simple pocket drawn in Fusion 360 and when I run the post process the Gcode it spits out gives me "k word given for arc in XY plane." Im guessing MAch 4 can only do arcs in one plane at a time. So does anyone know if there is a way to modify Fusion 360 so that the code given is only arcing in one plane at a time?
thanks in advance,
-
Ask on the fusion forum for problems with fusion 360 , it’s not a mach4 one
-
The X/Y plane IS one plane, isn't it?
-
Yes it is. I guess my guestion should have been, Has anyone set up fusion 360 so that the output is compatible with Mach 4? and in response to the first reply, I am asking there too. This isn't a problem with anything its simply a configuration problem specific to MACH 4 and Fusion.
-
I just figured it out, I think.... My ramp was set at "helix" and im thinking Mach 4 doesn't support that kind of plunging.
-
Just make sure you use th lasted the post and put in your personal post folder
http://cam.autodesk.com/posts/
Just type in Mach4
-
Just make sure you use th lasted the post and put in your personal post folder
http://cam.autodesk.com/posts/
Just type in Mach4
That did it, I had it in there but forgot to select it!! I knew it was going to be a bonehead mistake
-
FYI Mach3 and Mach4 both support helical ramping.
I use them all the time.
Mike.
-
FYI Mach3 and Mach4 both support helical ramping.
I use them all the time.
Mike.
Yeah I had the wrong post selected!!