Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Flipz01 on July 29, 2007, 03:19:56 PM
-
Anybody know what M108 is?
I just noticed it in the Initialization String, and I don't see it listed in the M-code table.
-
Sounds like you have a macro that is called with M108. Have a look in the macro folder and see if you have it there.
Hood
-
No, nothing there.
I'm trying to decide if this is written there when the program first loads, if it is a typo, or if I edited it by mistake.
Don't know, guessing it's a typo. But, from what I don't know.
-
go to MDI and type M108 and see if anything happens, but be ready at the E-Stop just in case.
Hood