Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kwheat on August 22, 2018, 02:16:55 PM

Title: z axis cutting to deep
Post by: kwheat on August 22, 2018, 02:16:55 PM

We cut foam 3d figures from sliced models. was cutting fine then started cutting to deep. Have checked home part zeros but no luck.  see pics any ideas? using Aspire. tool path preview looks good.

Title: Re: z axis cutting to deep
Post by: kwheat on August 22, 2018, 02:20:10 PM

I posted the wrong picture. Here is what the machine is doing.