Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: vcipriani on August 08, 2018, 12:11:16 PM
-
Hi Everyone
Just want to know if anyone knew where I can get info on how to setup and configure Mach3 software and my USB interface I just connected.
Thx
Vince
-
Hi,
what is your USB interface?
Craig
-
Not sure of the brand. But it is the one I purchased at the Buildyourcnc.com website. Here is the link
https://buildyourcnc.com/item/electronicsAndMotors-electronic-component-breakout-Mach3-USB-Board
Vince
-
Hi,
there are instructions on how to install it. Have you followed them? There is a .dll file to be put in the plugins folder and an .xml file
to be put in the base Mach folder.
Why buy a device that has no support? If you bought a US or European made board they work as they are supposed to
and the manufacturer will help.
Craig