Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: George GR on August 07, 2018, 06:26:45 AM

Title: Mach3 DRO & toolpath NOT refreshing
Post by: George GR on August 07, 2018, 06:26:45 AM
Hi!
Few days now I have a little problem.
When I move to any axis the DROs and the toolpath screen not renewed. When I stop the movement then the DROs and toolpath screen jumps to the correct position. Even when I run a program (toolpath) they still frozen antil the job finish or I press RESET or Feed Hold. Then they jump again to the correct position. For some reson the g-code screen working right. It dosen't mater if I make the movemed via keyboard or pentant.
Any help!!!
 
Title: Re: Mach3 DRO & toolpath NOT refreshing
Post by: Ingevetl on October 10, 2019, 02:01:47 PM
Hawe the same problem hawe to power off everything to empty ees, than its working.
Title: Re: Mach3 DRO & toolpath NOT refreshing
Post by: deejay_56 on May 06, 2021, 02:29:16 PM
Hi. I'm having the same problem, and using Pokeys57cnc board. Have you resolved the problem and if so, how?
Title: Re: Mach3 DRO & toolpath NOT refreshing
Post by: Ingevetl on May 07, 2021, 10:35:00 AM
I'm having still the same problem, and using Pokeys57cnc board and wix hc whb04b-6 MPG Handwheel
Title: Re: Mach3 DRO & toolpath NOT refreshing
Post by: Anono-mouse on July 07, 2022, 07:45:36 AM
Updating PoKeys (Firmware and Software) to the latest version (v4.6.1) fixed this for me :)

Credit goes to PoLabs support for the solution
Title: Re: Mach3 DRO & toolpath NOT refreshing
Post by: stevenladner on February 16, 2023, 04:35:23 AM
Even though I have updated to the new version, I still get the same error. Should it be resolved?


geometry dash meltdown (https://geometrydashmeltdown.com)
Title: Re: Mach3 DRO & toolpath NOT refreshing
Post by: tesemebe on April 19, 2023, 12:50:30 AM
I'm still having the same issue, and I'm making use of a Pokeys57cnc board in conjunction with a wix hc whb04b-6 MPG Handwheel.


backrooms game (https://backroomsgame.io)