Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Mr. Technical on July 25, 2007, 04:38:27 PM
-
Hello All,
I am trying to set up a trial version of Mach 3 to work with a 3rd party break out board. The instructions that came with the board refer to going into 'Config/State'. I have been unable to find that in the Config menu. Am I looking in the wrong place, or do I need to buy the full version to get access to that area? I plan to buy soon, but have to recuperate a little from the cost of the mill. Any help is greatly appreciated. Thanks!!
Ian
-
Which version are you running? I think that was for the older Ver 1.84. The menu's have been changed on the newer versions.
William
-
There used to be two pages, one called config state and the other I think config logic. They have now been combined into one page called general config. You can get to it from the Config tab.
Hood