Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: GPDC on July 24, 2007, 11:58:07 AM
-
HELP!
somewhere exists a chart of all the mouse pointer inputs (Mach commands) and the keystrokes I need to use to simulate those inputs...but I can't find it.
Probably the simplest of which is "ALT-R" for "start" & "tab" gets me the jog screen....
I need to tie the "Ref All Home" command into my PLC control circuit (and the IPAC) to prevent further crashes.
many thanks in advance for your help.....George P.
-
I think they are in the customisation manual, it gives you the scan codes and you have to look them up in an ascii table.
Hood
-
BTW the Home key on your keyboard should be the key for referencing all axis.
Hood