Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DennisF on July 20, 2007, 11:09:56 AM
-
Hello Art and Brian
I have just downlaoded the latest Mach version and found that when the program is asked to go to Z it cut's the fresh turned part off on X and then returns to Z zero it didnt do this in the previous version's the program always rapid the Z to zero and then the X to zero can you guy's fix that ?
Rg's
Dennis
-
Dennis,
I use turn a lot and might be able to help. What are you doing? Are you running a wizard? Which one?
Arnie
-
Hi Dennis
Hears the Mach3R 2.01.000 lock-down exe, Z is working in it properly.
Thanks, Chip
-
Hello Arnie
Funny thing i was on the phone with Chip and we tried the turn wizzard just inputing random info and it worked, now it seams it's working maybe it was the vbersion i was using.
Are you using a cad/cam type program for your design if so which one?
Thanks Chip i have downlaoded the file 2.01.000 thanks again for all your help.
Rg's
Dennis
-
Dennis,
I am just using the wizards, they seem to work well for the simple stuff I do.
I made a couple of other ones to suppliment them, one to do an o-ring groove on an ID, some to turn a taper up to a flat face, a modified OD groove (that doesn't pull all the way out between pecks), one to do a o-ring groove on a faced end, and a partially done elipse (I struggled a lot with that one).
Arnie
-
Arnie
Well at least your machining parts i am just struggling.
Dennis
-
Hey Chip
I tried to install that version and for some reason it wouldn't go.
Dennis