Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: hopeyeu on May 06, 2018, 11:18:47 PM

Title: Does anyone have a clue?
Post by: hopeyeu on May 06, 2018, 11:18:47 PM
Why should persistent jogging be so mysterious?

I can't jog the machine after stopping it in the middle of a run. I was able to do it; now I can't anymore.
The code has not changed, but the config has. I went from v68 to v66 because it was suggested that the 66 is a better version.
I had this issue before I changed versions of Mach 3. The keyboard does not do it, nor does the virtual pendant. I am stuck.

Hope
Title: Re: Does anyone have a clue?
Post by: Tweakie.CNC on May 07, 2018, 01:31:39 AM
There have been many problems reported with version .066 and as a result version .062 is now the preferred choice.

Your best bet would be to roll back to your previous version that worked the way you liked.

Tweakie.