Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: plasmashine on April 16, 2018, 03:06:22 AM
-
Hi
Ive just been upgrading my plasma table, but I must have inadvertantly changed a setting somewhere.
When I click 'spindle toggle' in diagnostics it turns on and off my plasma 'cut' relay.
But when I type in M03 or M04 it doesn't operate.
Also if I turn on the relay with the screen button it won't switch off with M05
Could someone just give me a nudge?
-
This can be caused by a corruption to the .xml file. Try Operator / Restore Settings and roll back to an earlier time (before the problem occurred).
Tweakie.
-
or lost files, have a look here:
http://www.machsupport.com/forum/index.php/topic,36874.0.html
-
Thanks I think it may be a corrupt file.