Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: cruz on April 12, 2018, 01:43:44 PM
-
hi everyone,
i'm new here on the forum,
i recently bought a cnc plasmatable and a hypertherm 105.
the problem i now have is when i load part in mach3 and hit start,
the torch goes to its starting possiotion but then the Z axis start going slowly up and it doesn't stop doing this until it is out of travel.
thc is on and in sheet cam the correct parameters are giving for the part
any help would be highly appreciated