Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: thespindoctor on April 08, 2018, 11:46:03 AM
-
Having trouble getting the correct voltage values in Mach4 from a Pokeys57E.
I measure voltage at the analog input pins up to 3 volts max but Mach4 registers only see about .8 volts
Does anyone have an idea what is going wrong. Tech support has not responded with anything helpful yet.
Thanks so much. Up against a deadline so getting panicked....
Keith
-
Reply from Polabs this is correct. Register is fraction of total value. So 1=3.3 volts
-
in this video i've used the analog inputs :-) https://www.youtube.com/watch?v=U1z1RcfykGA&t=28s