Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: jlr7kca on March 31, 2018, 03:58:01 PM

Title: Question mark flag on Mach3 Puseling Driver in Device manager
Post by: jlr7kca on March 31, 2018, 03:58:01 PM
Downloaded Mach3 Lic. and software, I have found a Question mark symbol "?" attached to the driver in Device manager that I need to remove, my cnc router motors will not run, I'm using Windows 7 32bit, 5Axis 004393 Breakout Board with M335 Drivers.
Thanks
Jon
Title: Re: Question mark flag on Mach3 Puseling Driver in Device manager
Post by: joeaverage on March 31, 2018, 04:47:04 PM
Hi,
run DriverTest.exe and report the results.

Craig
Title: Re: Question mark flag on Mach3 Puseling Driver in Device manager
Post by: jlr7kca on April 03, 2018, 09:48:16 AM
Thanks for the reply

DriverTest.exe run completed, no issues.

Jon
Title: Re: Question mark flag on Mach3 Puseling Driver in Device manager
Post by: Sorin on February 13, 2019, 02:38:44 PM
Hi did you solve problem with symbol ? because i have same problem
Title: Re: Question mark flag on Mach3 Puseling Driver in Device manager
Post by: reuelt on April 20, 2019, 11:02:19 AM
@JON & @SORIN
JUST Apply the fix listed here
https://www.machsupport.com/forum/index.php?topic=38269.0
reboot
Then you can safely ignore the  "Question mark flag".
Title: Re: Question mark flag on Mach3 Puseling Driver in Device manager
Post by: Spur on May 28, 2019, 04:05:24 AM
Hi everyone, I am new to the forum. I have the same problem as Jon. I am using one of the earliest builds of Windows 7 32bit, so that I wouldn't have that kind of issues, as many other have, after windows update. For that reason the fix reuelt posted didn't work for me. So Jon, did you manage to fix this driver issue, and if you did, how?

Regards, Spiros