Machsupport Forum
Mach Discussion => FAQs => Topic started by: Budyman on March 30, 2018, 03:55:44 PM
-
I have proma THC 150 and mach3 is not recognizing my Z up. it sees Z down and THC on also torch on but not my Z up. Any ideas?
-
I got the proma THC controller to work in simulation mode but when I go to use it still runs into the metal any ideas
-
we hae worked through the same Thing here:
http://www.machsupport.com/forum/index.php/topic,36550.90.html
-
Thanks now my new issue is when you're getting ready to cut the torch starts its Pierce then just starts going up and never comes back down I have to stop the process. It works in simulation mode torch on Z up Z down and so forth.
-
Also I use sheetcam I was wondering what post processor I should use and I do not have a floating head any ideas