Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jokernippe on March 17, 2018, 10:39:06 AM
-
Hi,
I have bought Stepcraft 840 and I can't get it to work with Mach3...
When I'm trying to make a 100 x 100mm square it won't do it like it should do. It will be like a Signature....
What should I do or what am I doing wrong?
Thanks!
Thomas
Finland
-
Which Software / Interface do you have connected to your machine ?
Are you using the UC100 USB motion controller ?
Tweakie.
-
Hi,
I have Mach3
-
and a red car.
sorry ;D
-
Aspire
-
Hi,
according to the advertising material this machine is supplied with UCCNC software and a UC100 motion controller.
Do you in fact have either or both?
Craig