Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jacko on July 13, 2007, 05:27:33 AM

Title: mach 3 turn
Post by: Jacko on July 13, 2007, 05:27:33 AM

I made a router using "mach 3 mill" and then scrapped that and converted my lathe with the bits i salvaged. I am now using "mach 3 turn" to run my lathe.  Every thing is working fine except that i cant jog the x axis.  The axis and dro move ok when i jog z but nothing moves when i try to jog the x axis, not even the dro. The lathe is working  fine and runs programs ok.  Have i had a dodgy download or do i need to configure something. The office computer that i originally download mach onto is the same. ie only the z axis will jog.
thanks in advance
jacko

Title: Re: mach 3 turn
Post by: Brian Barker on July 22, 2007, 01:58:44 PM

With the Mach3 Turn screens you can only jog on the Manual screen AND You have to have the Jogging on :(

Hope that helps..
Brian

Title: Re: mach 3 turn
Post by: Jacko on July 23, 2007, 03:57:33 AM

i have since downloaded the latest version and everything now works fine.
thanks
jacko