Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: TPS on March 16, 2018, 08:57:39 AM
-
had a strange Thing today
run a simple Programm for seed Validation
g0x200y200
g0x0y0
then i pressed feed hold during the g0x200y200
when i tryed to start again got he following errormessage:
Fri - 13:53:40 ---Command too long , Block = G0 X21044981090020823000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000.0000 Y-518.5300 Z-205.0500 A-4962710013563463000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000.0000 B0.0000 C0.0000Line 0
Thomas
M3 v .022