Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Kurt Rose on March 03, 2018, 06:53:02 PM
-
Can someone please refresh my memory and tell me how to delay axis movement to let my spindle get up to RPM before it enters the cut.
-
Hi,
delay:
G04 P*********x *********x in seconds/milliseconds dependent on General Setup.
Craig
-
You may also want to consider Config. / Ports & Pins / Spindle Setup - set Spin Up delay etc.
Tweakie.
-
Thanks Tweakie, thats what i have been attempting but it makes no difference what value I put in the CW or CCW box. I now have 20 in both boxes and it does the same thing as if I have 1. Could it be another setting somewhere?