Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: AndreiD on February 06, 2018, 03:33:16 AM
-
Hello and please help.
I have built a cnc plasma, it woks fine for a while with Mach3 trial. After I bought a license I installed Mach3 on a new Windows xp installation. Now something very strange is happening. My out pin assignment is like this ( for x 3-step 2-dir, y 5-step 4-dir,z 7-step 6--dir, 9-Output#1), but when I make a manual command on z azix ,Output1 activate, when I command x axis, z axis is moving instead, only Y axis is working fine. I have change the PC and also interface board, but the result is the same. Inputs are functioning good. The machine is behave like this in any out pins configuration.
-
Hi AndreiD,
Could you please attach your .xml file.
This file is in your Mach3 folder and it is called <your profile>.xml (typically Mach3Mill.xml)
Tweakie.
-
Tweakie thank you for reply, but after few install/uninstall of Mach3 , things return to normal. I do not now where was the problem anyway.
-
I am pleased you have it sorted. :)
I was just concerned that you had posted a question 2 weeks ago and it had not received a reply.
Tweakie.