Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jenczu11 on February 01, 2018, 06:22:29 PM

Title: Mach3 Turn, can't jog, g-codes work normal
Post by: Jenczu11 on February 01, 2018, 06:22:29 PM

First of all i want to say hello to everyone because it is my first post. Second sorry for my bad english :/.
So i have a problem with Mach3 Turn, when i put my program with g-codes CNC works normally moves in every axis, but when i want to move it with keyboard it won't work, the jog control is not lit. I think that it is an issue with a program, i was tweaking my axis Z and Y point to compansate on a detail and one moment the jog on keyboard stoped working, also i can't jog in TAB menu or change any of the jog modes (previously one of switches was lit for cont. I think now zero). I tried restarting whole system and the problem persists.

Title: Re: Mach3 Turn, can't jog, g-codes work normal
Post by: TPS on February 02, 2018, 10:00:49 AM

jog mode enebled ?

Title: Re: Mach3 Turn, can't jog, g-codes work normal
Post by: Jenczu11 on February 04, 2018, 06:30:09 PM

Long story short, simple returning to previous settings helped. But thanks for your input TPS i could not enable it.