Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: corydoras on July 07, 2007, 05:34:40 PM

Title: Another NetMos 2nd paralell port thread
Post by: corydoras on July 07, 2007, 05:34:40 PM

Hi Folks

I know there has been several thread according problrms with adding another paralellport in this forum....and I´ve read them all....believe me:)

The Pci card is an StLab/Sunsway I-112 Pci paralellport aka Netmos 9805 PCI paralell port

I see that najnielkp have gotten in to work in another thread but unfortunately it didnt work for me
http://www.artsoftcontrols.com/forum/index.php?topic=2633.0

In this post there is also a screenshot of my device manager and this is what I have tried:

Installed the PCI card according to manual, and activated the second LPT port in Mach3, and put inn the I/O adress (in my case 9000) but no movement

I have also gone throu ever possible setting in the bios, but cant find anything about the added card, only the original onboard printer port.

Here are some screenshots of my config

Best reg
Cory

Title: Re: Another NetMos 2nd paralell port thread
Post by: vmax549 on July 07, 2007, 08:15:57 PM

Ok is the card installed in the computer now? If so what is the address shown in the device manager/properties?

Title: Re: Another NetMos 2nd paralell port thread
Post by: Azrael on July 07, 2007, 08:29:08 PM

Hi,
Sometimes it happens, that address in the device manager is not the same as in the bios. I have had similar problem ones, and when I changed the value at bios settings, everything worked fine. Remember, that's the Windows.
Cheers

Title: Re: Another NetMos 2nd paralell port thread
Post by: Chaoticone on July 07, 2007, 09:44:26 PM

Hey Cory, I have sent you a personal message.

Brett