Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Planobilly on December 22, 2017, 10:15:53 PM
-
Hi,
I just about got Mach 3 running properly. A couple of issues left.
1. When I touch off the tool on the part, what do I click on to send the height to the tool table? For now I measured the tool off the machine and put it in the tool table.
2. How do I set the soft limits?
I have a G54 question but for another day.
Thanks,
Billy
Strange little parts I am making from a 1883 loom!!! Not so hard to make but making a drawing from the part was a PITB!!!lol
(https://i.imgur.com/bQav3yJm.jpg)
-
I solved the issues.
Thanks,
Billy