Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: damo green on December 18, 2017, 08:20:17 PM
-
Are G16 polar moves limited to the x-y plane?
If they are limited to the x-y plane then I will use FORMULAS instead
Thanks in advance.
-
Read the manual.
Mach3Mill_1.84.pdf
Page 10-19
Section 10.7.7
"It is possible for G0 and G1 moves in the X/Y plane only to specify coordinates as a radius
and angle relative to a temporary center point."
Good luck with formulas. I found some limitations ...
Cheers
Roger