Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: halfmill on December 02, 2017, 04:01:39 PM

Title: Soft warning on z max
Post by: halfmill on December 02, 2017, 04:01:39 PM
below are a few lines of code.  I get the message "soft warning on Z-max". 
G55 setting are: x-10.0000 y-10.0000 z0.0 a0.0   
In soft limit settings, z is set to 0.0000

where is my code wrong for getting this error?  I have no other
z settings in the code except for the g55
please help

(bridge experiment)
%
g0g49g40g17g80g90
m6t0
g64
g20
g0g90g55
g1a-30f3500.0
g01a30f3500.0
g01y0.0625
g01a-30f3500.0
g01y0.1250

thanks bob
Title: Re: Soft warning on z max
Post by: joeaverage on December 02, 2017, 09:35:50 PM
Hi,
what is the Z setting in the G55 work offset?. Remember that the numbers in G55 will be in machine co-ords and your soft limits in machine
co-ords also. Does your Z axis Soft Limits min-max 'window' accommodate the G55 Z value without error?

Craig