Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Planobilly on November 26, 2017, 05:51:27 PM

Title: Mach3 not returning to part zero....ideas why??
Post by: Planobilly on November 26, 2017, 05:51:27 PM

Hi,

I ran a couple of pocket cuts and the x and y axis did not return to zero. x was .o13 and y was .061.

This was the last lines of the code.
g01 z0.500
g01 x0 y0 z0
m30
%

Any ideas what would cause this?

Thanks,

Billy