Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: lab auto man on November 14, 2017, 07:10:34 AM
-
I am trying to get a rotating 4 th axis working. I think I must be missing a setting in mach 3. My v carve tool path looks correct in V carve but when I save it and load i into Mach 3 it does not match . >:(
Any Ideas what I am doing wrong?
Thanks,
Todd
-
There's a setting or two in Config > Toolpath that needs to be checked. That may be it.
-
Gerry,
I believe I have that all set correctly, A is set for rotation and I rotate X around my Y axis.
thanks,
Todd