Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: rrc1962 on October 30, 2017, 04:19:19 PM
-
Does Mach4 have anything similar to Stop CV On Angles like Mach3 had?
Thanks
-
Well, you can set the feed rate for any angle from 0 - 179 degrees. So, setting the speed for angles above 90 degrees to 0 would work.
The mcCVTuning wizard can populate the table for you giving the same result.
But, the mcCVTuningWizardV3 wizard in this topic is far better. It's smart enough to set the feed rate for angles to maintain a tolerance you enter in the wizard.
http://www.machsupport.com/forum/index.php/topic,35860.msg245507.html#msg245507
-
Your CVTuningWizard is awesome. That should do the trick. Thanks.
-
Thanks
No problem