Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: blauderb on October 17, 2017, 05:27:17 PM
-
Could someone explain why can't reset after a -x or -y limit fault? Every time I hit reset it just faults again, no chance to do a manual override. If it's a +X or +Y limit I can reset then back it off the limit in jog mode.
-
Did you click the manual override button first?
-
axis limit override is gray out when mach 4 is disabled
-
Sorry, I thought you were using Mach3.