Machsupport Forum

Mach Discussion => Brains Development => Topic started by: parth1799 on October 05, 2017, 04:25:26 AM

Title: Modbus input output support works with parallel port?
Post by: parth1799 on October 05, 2017, 04:25:26 AM
Dear experts,

i have question regrading parallel port. can any one tell me, when i activate "modbus input output support" in "configuration port and pin" my parallel port works properly.

means i want to give input signal to mach3 using "modbus input output support" and i want to give output to parallel port for controlling breakout board. both are working together without problem????

i hope you can understand my question.

pls help me to figure out this problem.

thanks & regards
Parth Jetani