Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Ward Hagaman on October 02, 2017, 01:03:05 PM

Title: Was working fine now won't home or jog without stopping
Post by: Ward Hagaman on October 02, 2017, 01:03:05 PM
I've been very happily running Mach 3 on my Saturn router for almost a year. I have a windows laptop running smoothstepper with a CNCRouterparts control.

I made the mistake of unhooking the laptop to take to a friends to program an Ebike speed control (not sure if it's related or not). Usually I just run Vcarve and Mach 3, but this time I downloaded one file for the programming and that's it. In the future I'll just keep this laptop as an appliance and not mess with it!

Now when I try to jog to the home position it will move an unpredictable amount and then stop. If I try the step command for .100" it might move .030", or some other random amount. If I try to go home it'll say "homing Z axis and then just hang up.

Any ideas? I'm dead in the water!

Thanks for any help!

Ward
Title: Re: Was working fine now won't home or jog without stopping
Post by: Ward Hagaman on October 03, 2017, 11:04:21 AM
Actually, I think I found the problem! I have a USB MPG, and if I unplug it everything seems fine now. Maybe there was something with the routing of the wiring of the USB cable and the Laptop power cable and noise?

I can try re-routing the cables now that I know it's not a Mach setting.

Thanks everyone!

Ward