Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Daner on September 25, 2017, 04:03:02 PM
-
I reinstalled mach3 with the lic. and deleted the old user files (maybe still in the recycle bin)
I should have wrot the old pin numbers down but i dident.
I got the pin numbers from the industrial site.
What my problem is I cant get the router to move at all
On the keyboard it shows in the DRO screen that x - Y AND z are moveing withe the proper keys on the keyboard
Jogging tab is On
Im not sure where to look next
The router table is running with the E stop out but No signal to the Gantry
I rebboted still nothing in jog
Any Tips guys?
Thanks
Danny
-
I ran the driver test and its good.
For some reason I think its somthing to do with the parrelel ports
When i hit update drivers the gantry made a bump noise
sounded like it wanted to go
but still no movement after 10 hrs working on it
-
The most likely issue is that either your port or pin numbers are wrong.
-
Thanks
It was the printer cable
Working now