Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: avengine on September 25, 2017, 03:09:43 PM

Title: how to setup home to fix the (0,0)
Post by: avengine on September 25, 2017, 03:09:43 PM

I have setup home and limit switch for X and Y, on the machine diagnostic, I know they are working, since I can jog x & y and get them light up, but I don't know how to set the software to mark this as the 0,0 as a home, and what is the icon for me to move them back to this 0,0 (Home). sorry for this very beginner question.
is there some document on detail mach4 config setup? or video link etc.
thanks.

Title: Re: how to setup home to fix the (0,0)
Post by: joeaverage on September 25, 2017, 04:01:21 PM

Hi,
have you read Homing on page 16 of Mach4 Installation Manual from the Artsoft site?

Craig