Machsupport Forum
Tangent Corner => Bargain Basement => Topic started by: hancock on September 21, 2017, 02:21:24 PM
-
I'm looking for a "Mach3-Pro" with ModBus experience to connect the following setup:
- Serial Port COM1 (9 pins ) connected with DSub25-adapter to relay-card
- Relay-card pins 2-9 need to be addressed via Button in Mach3 (on/off via Mach3 brain)
It would be possible to work directly on the connected PC via Remote-access.
Your help will be of course be paid.
Looking forward to hear from any of you Pros out there ;)