Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: moorea21 on September 21, 2017, 12:06:12 PM

Title: Multiple axes for mach3 probe and home on 2 pins?
Post by: moorea21 on September 21, 2017, 12:06:12 PM

Can I use the circuit below with mach3? The idea is that I could run 'G28.1' and/or 'G31' for X and Y axes. See my previous post for the reasons if you're curious about why I'd want to do this. Would there be problems with doing 'probes' on more than 1 axis? Obviously I would only probe or home 1 axis at a time with this setup.