Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: tonypet20 on September 20, 2017, 09:03:11 PM

Title: Mach3 and Hicon 7754 Homing error
Post by: tonypet20 on September 20, 2017, 09:03:11 PM
Hi,

I setup my lathe with mach3 and Hicon 7754 with plugin version 1.38.01, everything works fine except for the error " ERROR Starting Homing for Axis 0" which i setup the homing for X axis. This is also happened in Y axis. Please help what could be wrong on this. I attached the pictures of my input pin config and the plugin setup with the error.

Thanks,

tonypet