Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: RoyalMachine on August 18, 2017, 11:00:31 AM
-
Hello,
I'm using an xbox 360 controller with Mach3 for my plasma/oxyfuel cutting table and there are a few buttons I'm not sure how to assign. I'm using F8 and F7 to control THC Up and THC Down while using a keyboard (so I can manually control the height while cutting). I can't find any obvious way of assigning these actions to a couple buttons on the controller.
I'm not sure if I need to use a macro or what but I was hoping someone would have an answer for how to do this.
EDIT: I may have put this in the wrong forum. Not sure if I'll end up needing a macro or whether it's something easy with the plugin but I imagine either the Plugin forum or the VB forum would have been more appropriate. My apologies.