Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: microsteam on August 16, 2017, 10:00:59 AM

Title: UC100 Win10 Motion Control Hardware; two UC100 sensed
Post by: microsteam on August 16, 2017, 10:00:59 AM

I am running Win10 64bit OS, Mach3, Heiz 400 CNC machine and a UC100.
At first it worked really well and I was pleased with it. I did not deliberatly change the UC100 setup.
Now when Mach3 starts up it senses two UC100 whether or not the UC100 is connected.

If the UC100 is connected and powered up then selecting the first UC100 starts the drive hardware but fails after about 1 second. The other fails immediately.
I would like to clear out all the UC100 software and start again but the install software does not give this option.
Has any one else seen this problem?
Can any one advise my on where the UC100 dlls or what ever are located.

Title: Re: UC100 Win10 Motion Control Hardware; two UC100 sensed
Post by: ger21 on August 16, 2017, 11:05:47 AM

You probably have two UC100 plugins in the Mach3\plugins\ folder. delete the older one.

Title: Re: UC100 Win10 Motion Control Hardware; two UC100 sensed
Post by: microsteam on August 16, 2017, 11:56:58 AM

There were indeed two dlls in the plugins dir. I removed one and it now works OK.
Thank you.