Machsupport Forum
Third party software and hardware support forums. => Galil => Topic started by: GrandpaXYZ on August 06, 2017, 04:15:44 PM
-
On the "Axis setup" tab of the galil plugin for Mach3 there's some checkbox for each axis labeled "Use Master Command Pos". Those are not shown in the galil plugin manual (page 10) and I've searched everywhere but cannot find any info about this feature.
Well, my system is in fact working fine without that but I'm really curious about what those checkbox are doing. Anyone knows what this is for ???
J-P
-
Bumping this up as it is really bugging me...
Anyone know what this is for ??? ??? ???
-
Hi
Well some years later and I have the same question ??