Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: LerninCNC on August 04, 2017, 07:51:30 PM

Title: -1.#IND Error Message
Post by: LerninCNC on August 04, 2017, 07:51:30 PM

Yesterday I was doing some motor tuning (changing microstepping on X and Y) and got this error code, -1.#IND showing in the X and Y axis DRO when I turned off microstepping.  Could not get the code to clear even after I reset the dip switches to their original configuration.  I uninstalled Mach (if it means anything ver 062) and reloaded and all is well now.  What does this code mean?  I always understood that you could run Mach without microstepping so I'm unsure what happened.

Thanks