Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Albolabris on July 31, 2017, 09:39:04 AM
-
On a fresh install of Mach3, when I open the plasma profile and go to the tab “Diagnostics” there are no lights listed under “Port 1 Pins current State” or “Input Signals current State”
But if I open the Mill Profile and go to the tab “Diagnostics” there are 5 lights listed under “Port 1 Pins current State” and the emergency light is flashing under “Input Signals current State”
Why are there no lights under the Plasma profile?
-
The 'Port 1 Pins current State' LED's do not always work as expected and they should be ignored.
The 'Input Signals current State' LED's should always work correctly.
Tweakie.