Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: gorf23 on July 30, 2017, 10:22:09 AM
-
if the stepper motor dro says 2 inch but actual distance traveled was 3 inch is the a formula
how to caculate new steps as per real distance traveled.. Sorry but my math isn't top notch..
Thanks gary
-
2/3 times your steps unit.
-
so if I am understanding this correct it should be like
DistanceTravled = 3 Steps unit = 1800
DroDistance = 2
x = DistanceTravled * Steps unit
new steps unit = DroDistance / x
Thanks gary
-
hi there are a few ways to do this. the best and most accurate is the way in the manual complete calculation ie ball screw pulleys motor ect then check with a Gage block or dial indicator. you could just plug in a different number up or down until 1" on dro = 1" traveled this isnt the most accurate but depending upon what machine you are running i am sure it has been done that way before.
mark