Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: shady on July 23, 2017, 09:50:32 PM
-
Hello all ,
i want lazy cam post processor for laser cutter/engraver that works with m10px/m11px and can control power s### and feed rate
-
shady,
There is no documentation for creating a post processor for LazyCam.
RICH
-
If it's any help I did produce a Lazycam Post Processor for laser use incorporating the M11/M10 commands some while back, it's in the.zip file in this post http://www.machsupport.com/forum/index.php/topic,21762.msg151284.html#msg151284
Tweakie.
-
ok ,
is there any cam program can support mach3 laser easily ?
-
Thanks Tweakie,
After a quick look at the PST file, think I have a flavor of how to be dangerous.
RICH
-
;D ;D ;D
Tweakie.