Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kdwiz57 on July 23, 2017, 04:57:21 PM
-
Hi everyone,
I'm new to mach3. During installation I ran the driver test and saw a message that the pulse rate was "too fast". Does this mean that mach will not run properly? If I must fix it where do I look to resolve this issue? Any help will be appreciated.
-
What is the pulse rate, and how steady is it?
Do you get a smooth, flat line?
-
the line is flat. rate is 28000 or so. the bar that in the instructions and show "excellent" is where mine says pulse rate too fast