Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: CSMG on July 11, 2017, 12:46:22 PM
-
All, the X axis appears to be jerky. 1 side is smooth, opposite side is jerking trying to catch up. Unuseable at the moment, any ideas where to look?
Thank you
Mike
-
is it a mechanical issue or an electrical issue?
what is your setup?
has it been previously working?
-
Thanks for the reply. I don't know yet. This is the first time that this has happened. I am going to take the coveres off and take the steppers off to see if they spin freely. While it is on the machine and in place, it is acting spuratic.
I will see what is happening and write back.
-
I'm having the same issues with my Y axis. I don't know much about my machine, but if I'm experimenting with my MOTOR TUNING to see if that helps. I wish i could be a better help, good luck!
-
I found the issue, one of the drivers on y was bad.