Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ToadSprockett on July 10, 2017, 06:02:52 PM
-
I've a K2 CNC that I just put back up, when I go to jog any of the axis's they only move one way. I tried changing the hotkeys and that didn't seem to help...
Any ideas?
Thanks
-Paul-
-
can you use the built in mpg to jog(hit 'tab' then try the arrows?)
-
Sounds as though the DIR pins are not set up correctly.
Cheers
Roger