Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: tgirard on July 03, 2017, 04:38:41 PM

Title: Latest Version of Mach4 doesn't run with PMDX-411
Post by: tgirard on July 03, 2017, 04:38:41 PM

I just updated to the latest version of Mach4 (Version 4.2.0.3390) and it killed motion control on the PMDX-411.
Has anyone else seen this?
Is this the right forum?
I'll shoot over to the PMDX site and see if they have a support channel I can report this in but I thought the Mach folks should know

Title: Re: Latest Version of Mach4 doesn't run with PMDX-411
Post by: Steve Stallings on July 03, 2017, 05:01:04 PM

The PMDX-411 has been tested and runs fine with build 3390 of Mach4. Something in
your profile must have gotten stepped on. If you want assistance, please provide
a copy of your "Packaged Profile" either here or as a private email to PMDX.

You can generate the Packaged Profile in Mach4 using HELP > Support > Generate Packaged Profile.

Be sure to do this while running the profile of interest.

Steve Stallings
www.PMDX.com