Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: BillT on July 03, 2017, 03:33:56 PM
-
I have an Integra 7766 running Mach3 with Teknic Clearpath servos. The Integra 7766 and the servos are running great. I'm trying to resolve a problem with a plugin that I am using in Mach3.
My Hicon debug window is enabled and opens normally as expected when Mach3 loads. Is the content of the debug session saved for retrieval, or is it lost when Mach3 is closed? If it is saved, where?
Thank you in advance....
regards,
BillT