Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Hazeldene on July 02, 2017, 05:50:40 PM
-
Hi all, I've been using vcarve pro to produce rotary toolpaths, something's obviously not right in my setting's but I can't figure out what, if anyone can help me out I'd be grateful :D
Here are some pics, one is a preview in vcarve, the other is the toolpath in mach, thanks.
Si
-
Check your generated Gcode - Does it contain a G90.1 or a G91.1 at the beginning ?
If it does not then change the IJ Mode in General Config. and then regen. toolpath.
Tweakie.
-
Thanks Tweakie, will try that later and let you know ;D
-
Hi Tweakie, yes it Doe's contain G91.1, tried changing ij and regenning, sadly no difference, do you think it might be a Vectric issue ?
Si
-
Actually, don't worry, I figured it out. In "Rotational" I unchecked "Rot 360 Rollover" .that did the trick ;D
Thanks for your help though.
Regards
Si
-
Excellent news, I am pleased you have found the problem.
Tweakie.